Installing an air conditioner in an RV with a hole cut in floor for venting? - used rv air conditioner
I've hidden a very small mobile home and the only place a small realistic a / c unit under a sofa area to install, but do not want to cut a hole in the side, but perhaps the bottom of the zipper for ventilation. What would be the best way for the smooth functioning of the ventilation and condensation should be used to help the fans? Thank you very much
Friday, January 8, 2010
Used Rv Air Conditioner Installing An Air Conditioner In An RV With A Hole Cut In Floor For Venting?
Subscribe to:
Post Comments (Atom)
3 comments:
Build an aluminum pan, drain take under his regime and lead to a garrison would do in the lower 1 / 2 ". Mount Unit / c 4" away from the wall and make a box to cover the upper part and the other between the device and the wall. Cut a hole in the ground next to the size of the A / C unit width wise as possible and as close as possible to the area between the appliance and the wall. Basically, this allows escape of air condenser fan and the R / c. The pan will catch the condensation, and let it drain through the open-air facility. Helping fans should not be required if the opening be not large enough. If you do not need to attend all the fans, make sure that flipped the A / C unit and drainage located fans. The operation of the device will tell you if you need the fans.
Might also work much better if you make a hole, partly on a metal grid with an installed filter. This would give the appearance of a factory installation, and to reduce the noise inside and outside.
Literateck!
I do not know how he thinks, to install the device in a position close to level through a hole in the earth. Typically, a residential and C required for the rear 3 / 4 of the unit outside and the rest inside. The Only RV / C, which I saw, mounted on the roof and do not believe that there are working in the opposite direction.
Hello
Do not install the device in the hive ac difficult to do and make the ground a stable set. Id do it on the roof or the rear end of the trailer
Post a Comment